LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Wiper System & Washer System) >> Repair Instructions >> Washer Solvent Container Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the hood.
  2. Drain the washer solvent from the washer solvent container.
    3. Fig 1: Removing/Installing Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper washer solvent container screw.
  4. Remove the right front fender liner. Refer to Fender, Fender Insulator, Wheelhouse Liner Replacement - Front in Body Front End.
    5. Fig 2: Identifying Washer Pump Hose, Washer Pump Electrical Connector, & Washer Solvent Level Sensor
    GM815208Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the washer pump hose.
  6. Disconnect the washer pump electrical connector.
  7. Disconnect the washer solvent level sensor electrical connector.
  8. Remove the washer pump from the container.
  9. Remove the level sensor from the container.
    10. Fig 3: Removing/Installing Upper Washer Solvent Container Screw
    GM1257439Courtesy of GENERAL MOTORS CORP.
  10. Remove the lower washer solvent container screws.
  11. Remove the washer solvent container from the right frame rail.
scientia non olet · About LEMON Manuals