Installation Procedure
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
- Warm the body panel with J 25070 to a minimum of 21°C (70°F).
- Remove 5 or 6 in of the protective liner at the front edge of the weld joint molding.
- Align and center the front edge of the weld joint molding with the front edge of the weld joint.
- Use hand pressure to press the weld joint molding into place.
- Continue to remove the protective liner from the molding, centering the molding and pressing it into the weld joint.
- Hand roll the loose ends.