LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Interior Trim) >> Repair Instructions >> Trim Panel Replacement - Rear Quarter Upper >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Trim Panel - Rear Quarter Upper
    GM1283311Courtesy of GENERAL MOTORS CORP.
  1. Position the upper quarter trim panel into place.
  2. Install the push-in retainers to secure the trim panel (1).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the quarter upper panel screw in the top of the panel.

    Tighten:  Tighten the Quarter upper panel screw to 3 N.m (27 lb in).

  4. Install the door weatherstrip onto the pinch weld flange.
  5. Install the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) .
scientia non olet · About LEMON Manuals