Garnish Molding Replacement - Windshield Pillar

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Garnish Molding - Windshield Pillar

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure Remove the instrument panel outer trim cover. Refer to Instrument Panel (I/P) Outer Trim Cover Replacement .
1	Cap, Windshield Side Upper Tip: Use a small flat-bladed tool to release the cap from the molding.
2	Screw, Windshield Side Upper Garnish Molding Tighten: 2 N.m (18 lb in)
3	Molding, Windshield Side Upper Garnish Tip: Pull the molding away from the windshield pillar to disengage the clips. Disconnect the electrical connector from the speaker.
4	Grille, Radio Windshield Side Garnish Molding
5	Speaker, Radio Windshield Side Garnish Molding
6	Clip, Windshield Side Garnish Molding (Qty: 2)