LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Replacement - Front Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Position Assurance Pin & Pretensioner Electric Connector
    GM858956Courtesy of GENERAL MOTORS CORP.
  1. Install the front seat into the vehicle.
  2. Engage the front seat hook attachments.
  3. Tip the seat forward, connect the pretensioner electric connector (1) and insert the position assurance pin (2).
  4. Connect the electrical body harness to the seat.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the adjuster to floorpan bolts.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

    6. Fig 2: Identifying Seat Belt Anchor Plate Nut
    GM370568Courtesy of GENERAL MOTORS CORP.
  6. Install the seat belt and nut.

    Tighten:  Tighten the nut to 42 N.m (31 lb ft).

  7. Install the front seat head restraint. Refer to Head Restraint Replacement - Front Seat .
  8. Inspect the front seat for proper operation.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 7 and to SIR Disabling and Enabling Zone 9 .
scientia non olet · About LEMON Manuals