LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Back Replacement - Rear (non-Folding) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rear seat back to the vehicle.
    2. Fig 1: Identifying Rear Non-Folding Seat Back Retainer Hooks
    GM1282486Courtesy of GENERAL MOTORS CORP.
  2. Hook the seat back hangers (1) into the metal slots.
    3. Fig 2: View Of Rear Non-Folding Seat Back
    GM1282476Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the rear seat back nuts to the latch bracket.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  4. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear .
scientia non olet · About LEMON Manuals