Seat Back Frame Replacement - Rear
WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Seat Back Frame Replacement - Rear
| Callout | Component Name |
|---|---|
|
NOTE:
Refer to Fastener Notice
in Cautions and Notices. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) . |
|
| 1 | Nuts, Seat Back Armrest (Qty: 4) |
| 2 | Armrest Assembly, Rear Seat Tighten: 10 N.m (88 lb in) |
| 3 | Bolt/Screw, Rear Seat Back Bolster (Qty: 4) Tighten: 4 N.m (35 lb in) |
| 4 | Panel, Rear Seat Back Bolster Cushion |
| 5 | Cover, Seat Back Bolster |
| 6 | Pad, Seat Back Bolster Tip: Remove the hog rings that attach the seat cushion cover to the seat cushion. |
| 7 | Bolt/Screw, Rear Seat Back Cushion Tighten: 25 N.m (18 lb ft) |
| 8 | Pad Assembly, Rear Seat Back |
| 9 | Cover Assembly, Rear Seat Back Cushion |
| 10 | Panel, Rear Seat Back Cushion |
| 11 | Panel, Rear Seat Back Cushion |
| 12 | Frame Assembly, Rear Seat Back |