LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Seat System) >> Repair Instructions >> Seat Back Cover Replacement - Rear Folding >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pulling Cover Down And Over Rear Seat Back Pad
    GM530933Courtesy of GENERAL MOTORS CORP.
  1. Install the cover to the rear seat back by pulling the cover down and over the pad.
  2. Reach inside of the right rear seat back cover and reposition the release pullstrap through the cover.
  3. Align the hook and the loop retainers.
    4. Fig 2: Securing Front Seat Back Cover (Split Bench)
    GM520405Courtesy of GENERAL MOTORS CORP.
  4. Use firm hand pressure in order to fasten the hook and the loop retainers, securing the rear seat back cover to the pad.
  5. Install the folding armrest, if equipped. Refer to Armrest Replacement - Rear Seat .
    6. Fig 3: Repositioning Cable On Seat Back
    GM530863Courtesy of GENERAL MOTORS CORP.
  6. Reposition the cable on the seat back.
  7. Reposition the seat trim flaps.
  8. Install new staples to the seat trim flaps.
  9. Return the seat back trim material to the original position.
    10. Fig 4: Identifying J-Hook Retainer At Bottom Of Seat Back
    GM530878Courtesy of GENERAL MOTORS CORP.
  10. Fasten the J-hook retainer at the bottom of the seat back.
    11. Fig 5: Removing/Installing Left Rear Seat Back & Seat Back Frame
    GM530836Courtesy of GENERAL MOTORS CORP.
  11. Install the left rear seat back to the seat back frame.
    12. Fig 6: Removing/Installing Right Rear Seat Back & Seat Back Frame
    GM530927Courtesy of GENERAL MOTORS CORP.
  12. Install the right rear seat back to the seat back frame.
    13. Fig 7: Identifying Seat Back Frame Pivot
    GM802802Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  13. Install the pivot bolts (1) to the seat back frame.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  14. Install the rear seat back bolsters. Refer to Seat Back Bolster Replacement - Rear Split Folding .
  15. Install the seat back. Refer to Seat Back Replacement - Rear (Non-folding)  or Seat Back Replacement - Rear (Folding) .
scientia non olet · About LEMON Manuals