Seat Back Cover Replacement - Rear (One Piece)

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear One Piece Seat Back Cover Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: Refer to Fastener Notice in Cautions and Notices. Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the rear seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) .
1	Bolts, Bracket Assembly (Qty: 2) Tighten: 25 N.m (18 lb ft)
2	Bracket Assembly, Rear Seat Back Tip: Pull from the bottom edge of the panel to remove.
3	Cover, Seat Back Cushion Tip: Remove the hog rings that attach the seat cushion cover to the seat cushion.
4	Pad Assembly, Rear Seat Back Cushion