Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Adjuster Cover Plates

Courtesy of GENERAL MOTORS CORP.

Place the adjuster covers on the seat adjuster.

Fig 2: Removing/Installing Front Seat Back Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Place the seat back frame on the adjuster covers.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the bolts that secure the seat back to the adjuster.
Tighten: Tighten the bolts to 24 N.m (18 lb ft).

Fig 3: Removing/Installing Front Seat Pan Bolts

Courtesy of GENERAL MOTORS CORP.

Install the seat pan.
Install the bolts that secure the seat pan to the adjuster.
Tighten: Tighten the bolts to 24 N.m (18 lb ft).

Fig 4: Installing Rear Cushion Cover (Front Seat)

Courtesy of GENERAL MOTORS CORP.

Install the seat pad and trim cover together.
Install the seat cushion J-hooks and the hook and loop retainers to secure the trim to the seat pan.
Press down on the cushion trim pad to secure the hook and loop retainers to the seat pad.

Fig 5: View Of Adjuster Bracket Electrical Harness Clip & Harness Retainer

Courtesy of GENERAL MOTORS CORP.

Install the electrical harness clip and the retainer on the adjuster bracket.

Fig 6: View Of Power Seat Motor Electrical Harness

Courtesy of GENERAL MOTORS CORP.

Connect the electrical harness to the seat motor harness.
Install the seat belt pretensioner. Refer to Seat Belt Buckle Pretensioner Replacement in SIR.
Install the seat belt bracket.
Install the seat trim panel. Refer to Seat Adjuster Track Cover Replacement - Front .

IMPORTANT: Inspect the drive cables. Verify that the cables are straight between the motors and the drive screws.

Install the front seat. Refer to Seat Replacement - Front Bucket .