LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Rear End) >> Repair Instructions >> Wiring Harness Replacement - Rear Compartment Lid >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear compartment.
  2. Remove rear compartment lid carpet. Refer to Compartment Lid Trim Replacement - Rear 
    3. Fig 1: Identifying Rear Compartment Lid Wiring Harness
    GM324449Courtesy of GENERAL MOTORS CORP.
  3. Disconnect all of the electrical connectors to the electrical components that are attached to the lid.
  4. Tie a string to the rear compartment lid wire harness. Ensure that the string is long enough to allow you to feed the harness back through the rear compartment lid.
  5. Pull the harness wire out of the rear compartment lid and remove the string.
  6. Remove the push-in retainer from the hinge.
  7. Loosen the rear compartment trim as required to access the rear compartment lid harness.
  8. Disconnect the harness in the rear compartment.
  9. Remove the harness.
scientia non olet · About LEMON Manuals