LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Rear End) >> Repair Instructions >> Wiring Harness Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the harness in the rear compartment.
  2. Connect the new harness to the string.
  3. Pull the string back through the rear compartment lid until the harness is inside of the rear compartment lid.
  4. Remove the string from the wire harness.
    5. Fig 1: Identifying Rear Compartment Lid Wiring Harness
    GM324449Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connectors to the electrical components that are attached to the rear compartment lid.
  6. Install the push-in retainer on the hinge.
  7. Install rear compartment carpet. Refer to Compartment Lid Trim Replacement - Rear 
  8. Close the rear compartment.
scientia non olet · About LEMON Manuals