LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 105 (Body Rear End) >> Repair Instructions >> Compartment Trim Panel Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the rear compartment.
  2. If equipped, remove the rear compartment convenience net and net retainers.
  3. Remove the sill plate. Refer to Compartment Sill Plate Replacement - Rear .
  4. Remove the floor trim panel. Refer to Floor Trim Plate Replacement - Rear .
  5. Remove the seat back. Refer to Seat Back Replacement - Rear (Non-folding) or Seat Back Replacement - Rear (Folding) in Seats.
    6. Fig 1: Identifying Rear Compartment Trim Panel Push-In Retainers
    GM900761Courtesy of GENERAL MOTORS CORP.
  6. Use J 38778  to remove the push-in retainers from the trim panels.
  7. Slide the panels off the metal supports.
  8. Remove the trim panels from the rear compartment.
scientia non olet · About LEMON Manuals