Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition coil (2).

Fig 1: View Of Ignition Coil Module And Module Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition coil screws (1).
Tighten: Tighten the screws to 4.5 N.m (40 lb in).
Connect the spark plug wires.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) or Battery Negative Cable Disconnect/Connect Procedure (LY7) in Engine Electrical.