LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (L26) or Battery Negative Cable Disconnect/Connect Procedure (LY7) .
  2. Remove the fuel tank assembly. Refer to Fuel Tank Replacement .
    3. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel tank pressure sensor electrical connector.
  4. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
scientia non olet · About LEMON Manuals