LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Strainer Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  1. Install the new strainer (4) to the reservoir.
  2. Support the reservoir with one hand. Grasp the strainer with the other hand. Twist the strainer into position.
  3. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
scientia non olet · About LEMON Manuals