LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP And Fuel Tank Components
    GM699561Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Disconnect the evaporative emission (EVAP) vapor pipe (7) from the EVAP canister (1), the fill limiter vent valve and the fuel sender assembly.
  3. Remove the EVAP vapor pipe.
scientia non olet · About LEMON Manuals