LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the coolant recovery reservoir. Refer to Coolant Recovery Reservoir Replacement in Engine Cooling.
  2. Remove the drive belt. Refer to Drive Belt Replacement (L26) in Engine Mechanical - 3.8L.
    3. Fig 1: Disconnecting/Reconnecting Electrical Connector To CMP Sensor
    GM389047Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector (2) from the camshaft position sensor (1).
    4. Fig 2: Removing/Installing Camshaft Position (CMP) Sensor
    GM12305Courtesy of GENERAL MOTORS CORP.
  4. Remove the camshaft position sensor bolt.
  5. Remove the camshaft position sensor from the engine front cover.
scientia non olet · About LEMON Manuals