LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Engine Control System - 3.8L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the left inner fender brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
  2. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
    3. Fig 1: View Of Air Cleaner Housing, Bolts, PCM & Harness
    GM444496Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner housing screws (2).
  4. Remove the air cleaner housing cover (1) from the air cleaner housing.
  5. Without disconnecting the powertrain control module (PCM) connectors, remove the PCM and the harness from the air cleaner housing.
    6. Fig 2: Removing/Installing Air Cleaner Housing
    GM444479Courtesy of GENERAL MOTORS CORP.
  6. Remove the air cleaner housing (1) by pulling the housing from the 2 rubber grommets (2) in the engine compartment.
  7. Inspect the air cleaner housing assembly for signs of damage and replace if necessary.
scientia non olet · About LEMON Manuals