LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor (KS) Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the KS bolt.

    Tighten:  Tighten the KS bolt to 23 N.m (17 lb ft).

    3. Fig 2: View Of Right Knock Sensor And Electrical Connector
    GM945742Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the original position.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals