LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: View Of Purge Line From The Purge Valve Solenoid
    GM1401467Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the purge line from the purge valve solenoid.
    3. Fig 2: Identifying Purge Solenoid Electrical Connector
    GM1394073Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve solenoid electrical connector.
    4. Fig 3: Locating Purge Line From The Manifold Side Of The Purge Valve Solenoid
    GM1344143Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the purge line from the manifold side of the purge valve solenoid.
    5. Fig 4: Identifying Purge Valve Solenoid
    GM1395512Courtesy of GENERAL MOTORS CORP.
  5. Remove the purge valve solenoid and bolt from the intake manifold.
scientia non olet · About LEMON Manuals