LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 2 (Left) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Left CMP Sensor - Intake
    GM1285241Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Left CMP Sensor Electrical Connector - Intake
    GM1285239Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP sensor electrical connector.
  4. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement in Power Steering System.
scientia non olet · About LEMON Manuals