LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Lucerne CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Control System - 3.6L (Ly7) - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement - Bank 2 (Left) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not disconnect the power steering fluid lines/hoses from the reservoir.
  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote Power Steering Fluid Reservoir Replacement in Power Steering System.
    3. Fig 1: View Of Left CMP Sensor Electrical Connector - Exhaust
    GM1285242Courtesy of GENERAL MOTORS CORP.
  3. Remove the camshaft position (CMP) sensor electrical connector.
    4. Fig 2: View Of Left CMP Sensor - Exhaust
    GM1285243Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP sensor bolt.
  5. Remove the CMP sensor.
scientia non olet · About LEMON Manuals