Microphone Inoperative - Caller Cannot Be Heard
WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
Microphone Inoperative - Caller Cannot Be Heard
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| Schematic Reference: OnStar Schematics Connector End View Reference: Cellular Communication Connector End Views DEFINITION: The OnStar® Call Center operator can clearly be heard but the operator is unable to hear the caller. |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
9 V | Go to Step 4 | Go to Step 5 |
| 4 | Measure the voltage from the cellular microphone signal circuit to the drain wire. Does the voltage measure greater than the specified value? |
9 V | Go to Step 7 | Go to Step 6 |
| 5 | Test the cellular microphone signal circuit for an open or short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 8 |
| 6 | Test the drain wire for an open. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 9 |
| 7 | Test the drain wire for a short to ground. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 10 |
| 8 |
|
- | Go to Step 13 | Go to Step 9 |
| 9 | Inspect for poor connections at the harness connector of the rearview mirror. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 12 |
| 10 | Inspect for poor connections at the harness connector of the communication interface module. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 13 | Go to Step 11 |
| 11 | Replace the rearview mirror assembly. Refer to Rearview Mirror Replacement
in Stationary Windows. Did you complete the replacement? |
- | Go to Step 13 | - |
| 12 | Replace the VCIM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 13 | - |
| 13 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |