Conditions for Clearing the DTC

WARNING: This page is about a different variant/trim than selected.

A current DTC Last Test Failed clears when the diagnostic runs and passes.
A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
Clear the DTC with a scan tool.

DTC P0864

Step	Action	Values	Yes	No
1	Did you perform the Diagnostic System Check - Vehicle?	-	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Turn ON the ignition with the engine OFF. IMPORTANT: Record all Failure Records before clearing the DTC. Using Clear Info erases the Failure Records from the ECM and TCM. Record the DTC Freeze Frame/Failure Records. Did you record any TCM Freeze Frame/Failure Records?	-	Go to Diagnostic Trouble Code (DTC) List/Type in Automatic Transaxle - 4T65-E	Go to Step 3
3	Clear the DTC Information with a scan tool. Turn the ignition OFF for at least 30 seconds. Start, and allow the engine to idle. Did DTC P0864 fail this ignition?	-	Go to Step 4	Go to Intermittent Conditions
4	Did any other transmission control module (TCM) DTCs set?	-	Go to Diagnostic Trouble Code (DTC) List/Type in Automatic Transaxle - 4T65-E	Go to Step 5
5	Replace the engine control module (ECM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	-	Go to Step 6	-
6	Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition?	-	Go to Step 7	Go to Step 2
7	Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed?	-	Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information	System OK