Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: The following conditions must be met prior to the ignition OFF test.

DTCs P0101, P0102, P0103, P0112, P0113, P0117, P0118, P0125, P0128, P0443, P0446, P0449, P0451, P0452, P0453, P0458, P0459, P0496, P0498, P0499, P0560, P0562, P0563, P0700, P2228, and P2229 are not set.
The ignition 1 voltage is more than 11 volts.
A refueling event is not detected.
The fuel volatility is not excessive.
The ambient air temperature is between 2-32°C (36-90°F).
The start-up intake air temperature (IAT) is between 2-32°C (36-90°F).
The start-up engine coolant temperature (ECT) is less than 40°C (104°F) and within 10°C (18°F) of the IAT.
The ECT is more than 74°C (165°F) at engine OFF.
The barometric pressure (BARO) is more than 68 kPa.
The fuel level is between 12-88 percent.
The engine run time is more than 10 minutes.
The vehicle traveled more than 8 km (5 miles) with vehicle speed above 3.2 km/h (2 mph).
The vehicle odometer displays more than 20 km (12.5 miles).
DTC P0442 runs once per ignition OFF cycle when the above conditions are met prior to engine shut-down.