Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
The following table illustrates the ECM connector locations:
DTC P0223
| ECM Connector Location | |
|---|---|
| C2 | C1 |
| Front of Vehicle | |
- Use the J 35616 Connector Test Adapter Kit for any test that requires probing the ECM harness connector or a component harness connector. See Special Tools .
- If there is a condition with the TP sensors the ECM defaults to reduced power mode for the entire ignition cycle, even if the condition is corrected.
- For an intermittent condition, refer to Intermittent Conditions .