Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

Before the ECM can report DTC P0101 failed, DTCs P0102, P0103, P0121, P0122, P0123, P0221, P0222, P0223, P0335, P0336, and P0338 must run and pass.
DTC P2176 is not set.
The engine is operating.
The MAF sensor signal is more than 11 grams per second.
The ignition 1 voltage is more than 10.5 volts.
The ECM detects more than 150 revolutions of the crankshaft.
DTC P0101 runs continuously once the above conditions are met for more than 2 seconds.