Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
The following table illustrates the ECM connector locations:
DTC P0011, P0014, P0021, or P0024
| ECM Connector Location | |
|---|---|
| C2 | C1 |
| Front of Vehicle | |
- Use the J 35616 Connector Test Adapter Kit for any test that requires probing the ECM harness connector or a component harness connector. See Special Tools .
- The engine oil condition has a major impact on the camshaft actuator system.
- A low oil level condition may set this DTC. The engine may require an oil change. Inquire with the customer when the last oil change was performed. You may also monitor the Engine Oil Life parameter with a scan tool. Advise the customer an oil change may be required.
- Inspect the engine for any recent engine mechanical repairs. An incorrectly installed camshaft, camshaft actuator, or timing chain can cause this DTC to set.
- For an intermittent condition, refer to Intermittent Conditions .