LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.6L - 1 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator & Tube
    GM1394091Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the oil level indicator from the oil level indicator tube.
  3. Remove the oil level indicator tube bolt.
  4. Remove the oil level indicator tube up through the exhaust manifold.
  5. If you are replacing only the oil level indicator tube seal, remove and discard the old seal.
scientia non olet · About LEMON Manuals