LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 3.6L - 1 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Front Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Front Cover
    GM1412167Courtesy of GENERAL MOTORS CORP.
  1. Install the engine front cover. Refer to Engine Front Cover Assemble .
    2. Fig 2: View Of Water Pump
    GM946142Courtesy of GENERAL MOTORS CORP.
  2. Install the water pump. Refer to Water Pump Replacement (LY7) .
  3. Install the camshaft covers.
  4. Install the drive belt tensor. Refer to Drive Belt Tensioner Replacement .
    5. Fig 3: View Of Crankshaft Balancer
    GM1394039Courtesy of GENERAL MOTORS CORP.
  5. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
    6. Fig 4: Coolant Recovery Reservoir
    GM466475Courtesy of GENERAL MOTORS CORP.
  6. Install the coolant overflow reservoir. Refer to Coolant Recovery Reservoir Replacement .
    7. Fig 5: Locating Power Steering Reservoir Mounting Stud Bolt
    GM1386751Courtesy of GENERAL MOTORS CORP.
  7. Install the power steering reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement .
  8. Install the upper radiator hose. Refer to Radiator Inlet Hose Replacement (3.6L) .
    9. Fig 6: View Of Generator Bolts
    GM1394079Courtesy of GENERAL MOTORS CORP.
  9. Install the generator assembly. Refer to Generator Replacement (LY7) .
  10. Install engine splash shield. Refer to Splash Shield Replacement - Engine .
    11. Fig 7: View Of ECM Bolts
    GM1394049Courtesy of GENERAL MOTORS CORP.
  11. Install the ECM module. Refer to Engine Control Module Replacement .
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LY7) .
scientia non olet · About LEMON Manuals