LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 3.6L - 5 Of 5) >> Off-Vehicle Repair Instructions (4 Of 4) >> Power Steering Pump Installation

Power Steering Pump Installation

WARNING: This page is about a different variant/trim than selected.
Tools Required

J 25033-C  Pulley Installer. See Special Tools

    Fig 1: Locating Power Steering Pump Front Bolt
    GM1395922Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.
  1. Place the power steering pump in position to the cylinder block.
  2. Loosely install the power steering front bolt in order to hold the power steering pump in position.
  3. Place the power steering front bracket in position.
    4. Fig 2: View Of Power Steering Pump Side Bolt
    GM1395920Courtesy of GENERAL MOTORS CORP.
  4. Loosely install the power steering side bracket bolt.
  5. Hold the power steering pump firmly against the engine block.
    6. NOTE: Refer to Fastener Notice .
  6. Tighten the power steering pump front bolt.

    Tighten:  Tighten the power steering pump front bolt to 50 N.m (37 lb ft).

  7. Install the power steering pump side bolt.

    Tighten:  Tighten the power steering pump side bolt to 50 N.m (37 lb ft).

    8. Fig 3: Installing Power Steering Pump Pulley Using J 25033-C
    GM1395919Courtesy of GENERAL MOTORS CORP.
  8. If removed, install the power steering pump pulley using the J 25033-C  . See Special Tools .
scientia non olet · About LEMON Manuals