LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 3.6L - 5 Of 5) >> Off-Vehicle Repair Instructions (4 Of 4) >> Drive Belt Installation

Drive Belt Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Drive Belt
    GM1395907Courtesy of GENERAL MOTORS CORP.
  1. Route the drive belt around the following:
    • Crankshaft balancer
    • Air conditioning compressor
    • Drive belt tensioner
    • Power steering pump
    • Water pump pulley
    • Generator
    2. Fig 2: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  2. Insert a 1/2 inch drive ratchet into the drive belt tensioner.
  3. Rotate the drive belt tensioner clockwise.
  4. Route the remainder of the drive belt around the drive belt idler pulley.
  5. Slowly rotate the drive belt tensioner counterclockwise until the drive belt is tight.
  6. Remove the 1/2 inch drive ratchet.
  7. Inspect the drive belt for proper seating in all pulleys.
scientia non olet · About LEMON Manuals