LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Mechanical - 3.6L - 5 Of 5) >> Off-Vehicle Repair Instructions (4 Of 4) >> Air Conditioning (A/C) Compressor Installation

Air Conditioning (A/C) Compressor Installation

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Follow the procedure sequence in order to prevent drive belt mis-alignment and/or possible damage/distortion to the components.
    Fig 1: Air Conditioning Compressor Bolts And Nut
    GM1539064Courtesy of GENERAL MOTORS CORP.
  1. Place the A/C compressor in position to the cylinder block.
  2. Loosely install the A/C compressor bolts (1, 3) and nut (2).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the A/C compressor front bolt (3).

    Tighten:  Tighten the A/C compressor front bolt (3) to 50 N.m (37 lb ft).

  4. Tighten the A/C compressor front nut (2).

    Tighten:  Tighten the A/C compressor front nut (2) to 50 N.m (37 lb ft).

  5. Tighten the A/C compressor rear bolt (1).

    Tighten:  Tighten the A/C compressor rear bolt (1) to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals