LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L - 4 Of 5) >> Off-Vehicle Repair Instructions (3 Of 4) >> Oil Pump Installation

Oil Pump Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Pump Bolts
    GM1579118Courtesy of GENERAL MOTORS CORP.
  1. Align the oil pump generator with the crankshaft flats and install the oil pump to the engine block.
  2. Align the pump body with the mounting holes in the cylinder block.
    3. NOTE: Refer to Fastener Notice .
  3. Install the oil pump bolts.

    Tighten:  Tighten the oil pump bolts to 23 N.m (17 lb ft).

scientia non olet · About LEMON Manuals