LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L - 4 Of 5) >> Off-Vehicle Repair Instructions (3 Of 4) >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW O-ring on the oil level indicator tube.
    2. Fig 1: Identifying Oil Level Indicator & Tube
    GM1395941Courtesy of GENERAL MOTORS CORP.
  2. Install the oil level indicator and tube by sliding the tube down through the lower crankcase hole.
    3. NOTE: Refer to Fastener Notice .
  3. Install the oil level indicator tube bracket bolt.

    Tighten:  Tighten the oil level indicator tube bracket bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals