Exhaust Manifold Installation - Right Side

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Crankshaft Position Sensor O-Ring

Courtesy of GENERAL MOTORS CORP.

Fig 2: View Of Crankshaft Position Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the crankshaft position sensor bolt.
Tighten: Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

Fig 3: View Of Right Knock Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

Position the right knock sensor to the cylinder block as shown.
Install the knock sensor bolt.
Tighten: Tighten the knock sensor bolt to 23 N.m (17 lb ft).
Ensure proper knock sensor orientation.

Fig 4: View Of Block Heater Cartridge

Courtesy of GENERAL MOTORS CORP.

Fig 5: Identifying Exhaust Manifold Bolts To Right Cylinder Head

Courtesy of GENERAL MOTORS CORP.

Position a NEW exhaust manifold gasket onto the right exhaust manifold.
Install the exhaust manifold bolts into the right exhaust manifold.
Place the right exhaust manifold, exhaust manifold gasket and bolts as an assembly in position on the right cylinder head.
Install the exhaust manifold bolts into the right cylinder head.
Tighten: Tighten the exhaust manifold bolts to 25 N.m (18 lb ft).

Fig 6: View Of Right Exhaust Manifold Heat Shield & Bolts

Courtesy of GENERAL MOTORS CORP.

Place the right exhaust manifold heat shield in position.
Install the exhaust manifold heat shield bolts.
Tighten: Tighten the exhaust manifold heat shield bolts to 10 N.m (89 lb in).