LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 3.6L - 3 Of 5) >> Off-Vehicle Repair Instructions (2 Of 4) >> Oil Pan Assemble

Oil Pan Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Suction Tube Seal & Oil Suction Tube
    GM1318091Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    2. Fig 2: Identifying Oil Suction Pipe Bolts
    GM1658750Courtesy of GENERAL MOTORS CORP.
  2. Install the oil suction pipe.
    3. NOTE: Refer to Fastener Notice .
  3. Install the oil suction pipe bolts.

    Tighten:  Tighten the oil suction pipe bolts to 10 N.m (89 lb in).

    4. Fig 3: Identifying Oil Pan Scraper
    GM1658747Courtesy of GENERAL MOTORS CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts.

    Tighten:  Tighten the oil pan scraper bolts to 10 N.m (89 lb in).

    6. Fig 4: Identifying Oil Pan Drain Plug
    GM1658744Courtesy of GENERAL MOTORS CORP.
  6. Install the oil pan drain plug and NEW O-ring seal.

    Tighten:  Tighten the oil pan drain plug to 20 N.m (15 lb ft).

scientia non olet · About LEMON Manuals