LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 3.6L - 3 Of 5) >> Off-Vehicle Repair Instructions (2 Of 4) >> Intake Manifold Assemble >> Upper Intake Manifold Assemble Procedure

Upper Intake Manifold Assemble Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Intake Manifold Opening Cover Bolts
    GM1531033Courtesy of GENERAL MOTORS CORP.
  1. Install the intake manifold opening cover.
  2. Install the intake manifold opening cover bolts.

    Tighten:  Tighten the intake manifold opening cover bolts to 10 N.m (89 lb in).

    3. Fig 2: Identifying Barometric Pressure (BARO) Sensor Bolt
    GM1408451Courtesy of GENERAL MOTORS CORP.
  3. Install the barometric pressure (BARO) sensor.
  4. Install the BARO sensor bolt.

    Tighten:  Tighten the BARO sensor bolt to 10 N.m (89 lb in).

    5. Fig 3: Locating Throttle Body Bolts
    GM1408449Courtesy of GENERAL MOTORS CORP.
  5. Install the NEW throttle body gasket.
  6. Install the throttle body.
  7. Install the throttle body bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

    8. Fig 4: Fuel Rail Support Bracket
    GM1531030Courtesy of GENERAL MOTORS CORP.
  8. Install the fuel rail support bracket.
  9. Install the fuel rail support bracket bolt.

    Tighten:  Tighten the fuel rail support bracket bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals