LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical - 3.6L - 3 Of 5) >> Off-Vehicle Repair Instructions (2 Of 4) >> Camshaft Cover Assemble >> Left Camshaft Cover

Left Camshaft Cover

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Ignition Coil Seals With J 5590 And J-25254-A
    GM1836408Courtesy of GENERAL MOTORS CORP.
  1. Install the NEW left spark plug shield tube seals using the J 5590  and J-25254-A  . See Special Tools .
    2. Fig 2: View Of Left Camshaft Cover Gasket
    GM1833736Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW left camshaft cover gasket.
    3. Fig 3: View Of Oil Fill Cap
    GM1833733Courtesy of GENERAL MOTORS CORP.
  3. Install the oil fill cap.
    4. Fig 4: View Of Fuel Injector Sight Shield Ballstud
    GM1833730Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the fuel injector sight shield cover ballstud.

    Tighten:  Tighten the fuel injector sight shield cover ball stud to 10 N.m (89 lb in).

    5. Fig 5: View Of Left Camshaft Cover & Bolt Grommets
    GM1832347Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.
  5. Install the NEW left camshaft cover bolt grommets.
scientia non olet · About LEMON Manuals