LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> On-Vehicle Repair Instructions (2 Of 2) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition OFF.
    2. Fig 1: Identifying Oil Pressure Sensor Electrical Connector
    GM1394025Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the oil pressure sensor electrical connector.
    3. Fig 2: Engine Oil Pressure Sensor
    GM1401653Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil pressure sensor.
scientia non olet · About LEMON Manuals