LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> On-Vehicle Repair Instructions (2 Of 2) >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing & Installing Oil Level Switch
    GM1213854Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  2. Disconnect the electrical connector from engine oil level switch.
  3. Remove the engine oil level switch from the oil pan.
scientia non olet · About LEMON Manuals