LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> Off-Vehicle Repair Instructions (1 Of 4) >> Intake Manifold Removal

Intake Manifold Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Brake Booster Hose
    GM1530988Courtesy of GENERAL MOTORS CORP.
  1. Disconnect and remove the brake booster hose from the upper intake manifold.
    2. Fig 2: EVAP Hose
    GM1530992Courtesy of GENERAL MOTORS CORP.
  2. Disconnect and remove the vehicle-to-solenoid evaporative emission (EVAP) hose from the EVAP solenoid.
    3. Fig 3: EVAP Hose Bracket Bolt
    GM1530995Courtesy of GENERAL MOTORS CORP.
  3. Remove the intake manifold-to-solenoid EVAP hose bracket bolt from the intake manifold.
  4. Disconnect and remove the intake manifold-to-solenoid EVAP hose from the intake manifold and from the EVAP solenoid.
    5. Fig 4: EVAP Solenoid Bolt
    GM1530999Courtesy of GENERAL MOTORS CORP.
  5. Remove the EVAP solenoid bolt.
  6. Remove the EVAP solenoid.
    7. Fig 5: Dirty Air PCV Hose
    GM1531001Courtesy of GENERAL MOTORS CORP.
  7. Disconnect and remove the dirty air positive crankcase ventilation (PCV) hose from the intake manifold and the right camshaft cover fitting.
    8. Fig 6: Clean Air PCV Hose
    GM1531006Courtesy of GENERAL MOTORS CORP.
  8. Disconnect and remove the fresh air PCV hose from the left camshaft cover fitting.
    9. Fig 7: Intake Manifold
    GM1531007Courtesy of GENERAL MOTORS CORP.
  9. Remove the intake manifold bolts.
  10. Remove the intake manifold assembly.
    11. Fig 8: View Of Lower Intake Manifold Gasket
    GM902883Courtesy of GENERAL MOTORS CORP.
  11. Remove the lower intake manifold gasket.
scientia non olet · About LEMON Manuals