LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> Off-Vehicle Repair Instructions (1 Of 4) >> Exhaust Manifold Removal - Right Side

Exhaust Manifold Removal - Right Side

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Right Exhaust Manifold Heat Shield & Bolts
    GM1395938Courtesy of GENERAL MOTORS CORP.
  1. Remove the right exhaust manifold heat shield bolts.
  2. Remove the right exhaust manifold heat shield.
    3. Fig 2: Identifying Exhaust Manifold Bolts To Right Cylinder Head
    GM1395939Courtesy of GENERAL MOTORS CORP.
  3. Remove the exhaust manifold bolts from the right cylinder head.
  4. Remove the right exhaust manifold.
  5. Remove and discard the exhaust manifold gasket.
    6. Fig 3: View Of Block Heater Cartridge
    GM945970Courtesy of GENERAL MOTORS CORP.
  6. Remove the block heater cartridge, if equipped.
    7. Fig 4: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS CORP.
  7. Remove the right knock sensor bolt.
  8. Remove the right knock sensor.
    9. Fig 5: View Of Crankshaft Position Sensor & Bolt
    GM902802Courtesy of GENERAL MOTORS CORP.
  9. Remove the crankshaft position sensor bolt.
  10. Remove the crankshaft position sensor.
    11. Fig 6: View Of Crankshaft Position Sensor O-Ring
    GM1412145Courtesy of GENERAL MOTORS CORP.
  11. Remove and discard the crankshaft position sensor O-ring, if damaged.
scientia non olet · About LEMON Manuals