LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Mechanical - 3.6L - 2 Of 5) >> Off-Vehicle Repair Instructions (1 Of 4) >> Drive Belt Removal

Drive Belt Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Drive Belt Tensioner & Pulleys
    GM284263Courtesy of GENERAL MOTORS CORP.
  1. Insert a 1/2 inch drive ratchet into the outer drive belt tensioner.
  2. Rotate the drive belt tensioner clockwise.
  3. Remove the drive belt from around the drive belt idler pulley.
  4. Slowly rotate the drive belt tensioner counterclockwise.
  5. Remove the 1/2 inch drive ratchet.
    6. Fig 2: Identifying Drive Belt
    GM1395907Courtesy of GENERAL MOTORS CORP.
  6. Remove the drive belt from around the following:
    • Crankshaft balancer
    • Generator
    • Air conditioning compressor
    • Power steering pump pulley
    • Water pump pulley
    • Drive belt tensioner
scientia non olet · About LEMON Manuals