LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left Knock Sensor
    GM860802Courtesy of GENERAL MOTORS CORP.
  1. Install the KS.
    2. NOTE: Refer to Fastener Notice .
  2. Install the KS bolt.

    Tighten:  Tighten the KS bolt to 23 N.m (17 lb ft).

    3. Fig 2: View Of Left Knock Sensor And Electrical Connector
    GM945380Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector.
  4. Install the wiring harness heat shield to the oil level indicator tube.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals