LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Digital Pressure Gauge, Special Tools & Components
    GM1828580Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure, if required. Refer to Fuel Pressure Relief .
    2. CAUTION: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the connection of the fuel pressure gage is complete.
  2. Wrap a shop towel around the fuel pressure service port.
  3. Remove the CH-48027-3 (4) fitting from the fuel pressure service port.
  4. Place the shop towel into an approved container.
  5. Install the fuel pressure service port cap.
scientia non olet · About LEMON Manuals