Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Left CMP Sensor - Intake

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the CMP sensor bolt.
Tighten: Tighten the CMP sensor bolt to 10 N.m (89 lb in).

Fig 2: View Of Left CMP Sensor Electrical Connector - Intake

Courtesy of GENERAL MOTORS CORP.

Install the CMP sensor electrical connector.
Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement in Power Steering System.