LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Actuator Solenoid Replacement - Bank 2 (Left Side) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Left CMP Actuator Valve - Intake
    GM1285234Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP actuator valve.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the CMP actuator valve bolt.

    Tighten:  Tighten the CMP actuator valve bolt to 10 N.m (89 lb in).

    3. Fig 2: View Of Left CMP Actuator Valve Electrical Connector - Intake
    GM1285232Courtesy of GENERAL MOTORS CORP.
  3. Install the CMP actuator valve electrical connector.
  4. Install the power steering fluid reservoir. Refer to Remote Power Steering Fluid Reservoir Replacement in Power Steering System.
scientia non olet · About LEMON Manuals