LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2007 >> Allure CX >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Seat Hardware, Seat Trim And Upholstery) >> Repair Instructions >> Front Seat Replacement - Bucket >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick LaCrosse and 2008 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Position Assurance Pin & Pretensioner Electric Connector
    GM858956Courtesy of GENERAL MOTORS CORP.
  1. Install the front seat into the vehicle.
  2. Engage the front seat hook attachments.
  3. Tip the seat forward, connect the pretensioner electric connector (1) and insert the position assurance pin (2).
  4. Connect the electrical body harness to the seat.
    5. NOTE: Refer to FASTENER NOTICE .
  5. Install the adjuster to floorpan bolts.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

    6. Fig 2: Identifying Seat Belt Anchor Plate Nut
    GM370568Courtesy of GENERAL MOTORS CORP.
  6. Install the seat belt and nut.

    Tighten:  Tighten the nut to 42 N.m (31 lb ft).

  7. Install the front seat head restraint. Refer to Front Seat Head Restraint Replacement .
  8. Inspect the front seat for proper operation.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals